Hino J08C-TP, J08C-TR — CAMSHAFT HOUSING AND CYLINDER HEAD

1 page 1 Models J08C-TP and J08C-TR 3-6-20 ENGINE MOUNTING 1. INSTALL THE CYLINDER HEAD GASKET. NOTE: COOLANT GEAR CASE PRINTED SEAL SEAL RING G Never reuse the cylinder head gasket as it may cause engine damage. G Before installing the cylinder head gasket, remove dirt, moisture and oil on the cylinder head and cylinder block surface. G The coolant seal rings between the bores are easily damaged. Do not touch them with your hands or other objects. Make sure that the seal rings are not loose or damaged. G Since silicon material is used for the gear case print seal, make sure that there is no peeling before as- sembly. 1.

Install the cylinder head gasket on the cylinder block and flywheel housing. 2. Fill the hole at the back of the cylinder head gasket with liquid gasket. NOTE: Make sure that the liquid gasket surface is flush with the cylinder head gasket upper surface. SM3-J268 Fig. 64 LIQUID GASKET APPLICATION POINT PRINT SEAL LIQUID GASKET APPLICATION POINT LIQUID GASKET CYLINDER HEAD CYLINDER BLOCK FLYWHEEL HOUSING CLEARANCE CORRECT REAR END PLATE TOO POOR CLEARANCE CLEARANCE PROTRUDING A-A SECTION SM3-J075 Fig. 65 2. INSTALL THE CYLINDER HEAD ON THE CYLINDER BLOCK. SM3-J627 Fig. 66 3. INSTALL THE CYLINDER HEAD BOLT. 1. Preparation a.

Measure the length of the M12 head bolts, if the length is A or more, replace with new bolts. A = 126 mm (4.9606 in.) b. Make sure that no dirt or scratch is on the tightening surface of the cylinder head bolt. A SM3-J076A Fig. 67