1 page 1 Models J08C-TP and J08C-TR 3-7-6 ENGINE INSPECTION AND REPAIR INSPECT THE TORSIONAL DAMPER. NOTE: Clean the torsional damper with a commercial cleaning agent before inspection. 1. Check if there are any cracks in the damper rubber section. If the cracks are excessive, replacement is necessary. SM3-J661 Fig. 18 INSPECT THE FLYWHEEL (MODELS: FD, FE, FF) 1. Check the friction surface for scoring or heat crack- ing. If necessary, grind the friction surface or replace the flywheel. Grind limit: 1 mm (0.039 in) Deflection limit: 0.04 mm (0.00157 in.) NOTE: Do not grind the flywheel over than the limit. 2. Using a straight edge and a feeler gauge, check the friction surface ware.
If the wear is greater than the sevice limit, replace the flywheel. Standard: 0.05 mm (0.0020 in.) or less Service limit: 1.0 mm (0.039 in.) Fig. 19 SM5-089 INSPECT THE FLYWHEEL (MODEL: SG) 1. Check the friction surface for scoring or heat crack- ing. If necessary, grind the friction surface or replace the flywheel. Grind limit: 1 mm (0.039 in) Deflection limit: 0.04 mm (0.00157 in.) NOTE: Do not grind the flywheel over than the limit. 2. Using a vernier caliper, check the friction surface ware. If the wear is greater than the sevice limit, replace the flywheel. Standard: 48 mm (1.890 in.) Service limit: 49 mm (1.929 in.) Fig. 20 SM5-040A A