Hino J08C-TP, J08C-TR — CRANKSHAFT FRONT END, OIL PAN, FLYWHEEL AND FLYWHEEL HOUSING

1 page 1 Models J08C-TP and J08C-TR ENGINE 3-7-7 3. After grind the friction surface, adjust the friction sur- face depth of the flywheel within the service stand- ard by grind the outer bosses of the flywheel. Fly wheel depth: 48 mm (1.890 in.) BOSS FRICTION SURFACE SM5-098A Fig. 21 INSPECT THE PILOT BEARING. Rotate the bearing lightly by hand, and check whether there is any abnormal noise or chatter, and whether the balls run smoothly. If there is any fault, replace the pilot bearing. SM3-J523 Fig. 22 INSPECT THE FLYWHEEL RING GEAR. Visually check the flywheel ring gear. Replace the parts if damage such as wear and scratches is excessive. REPLACE THE FLYWHEEL RING GEAR. 1.

Heat the ring gear evenly to about 200°C (392°F) with a blow torch. Tap the ring gear periphery lightly using a cushion bar to remove the gear. WARNING Never touch the ring gear or flywheel when they are hot with your bare hands. Fig. 23 SM3-J125 2. Heat the ring gear evenly to about 200°C (392°F) with a torch. Insert the ring gear into the flywheel so that the chamfered side is upward. NOTE: Do not overheat the ring gear.