1 page 1 Models J08C-TP and J08C-TR 3-7-8 ENGINE MOUNTING 1. INSTALL THE OIL SEAL RETAINER. 1. Clean the cylinder block mounting surface of the oil seal retainer. 2. Apply liquid gasket to the oil seal retainer, then in- stall it to the cylinder block within 20 minutes. Liquid gasket: ThreeBond No.1207B Coating width: 1.5 - 2.5 mm (0.06 - 0.10 in.) NOTE: MATCHING FLANGE FACE WITH THE BLOCK LIQUID GASKET SM3-J032 Fig. 24 G Refer to page 3-20-1. G If left more than 20 minutes, clean off the liquid gasket completely and reapply the liquid gasket. 2. INSTALL THE FLYWHEEL HOUSING. 1. Clean the rear end plate mounting surface of the fly- wheel housing. 2.
Apply liquid gasket to the flywheel housing, then in- stall it to the rear end plate within 20 minutes. Liquid gasket: ThreeBond No.1207B Coating width: 1.5 - 2.5 mm (0.06 - 0.10 in.) NOTE: MATCHING FACE WITH THE REAR END PLATE LIQUID GASKET G If left more than 20 minutes, clean off the liquid gas- ket completely and reapply the liquid gasket. G Refer to page 3-20-1. WARNING The flywheel is heavy. When installing, be careful not to drop it on your feet. SM3-J041 Fig. 25 MATCHING FLANGE FACE WITH THE FLYWHEEL HOUSING 3. INSTALL THE DUST COVER. 1. Clean the flywheel housing mounting surface of the dust cover. 2.
Apply liquid gasket to the dust cover, then install it to the flywheel housing within 20 minutes. Liquid gasket: ThreeBond No.1207B Coating width: 1.5 - 2.5 mm (0.06 - 0.10 in.) NOTE: FLYWHEEL HOUSING OPENING LIQUID GASKET Fig. 26 SM3-J035 G Refer to page 3-20-1. G If left more than 20 minutes, clean off the liquid gas- ket completely and reapply the liquid gasket.