1 page 1 Models J08C-TP and J08C-TR ENGINE 3-7-9 4. CRANK SHAFT OIL SEALS INSTALLATION (FRONT AND REAR). Special tools: Oil seal press (09407-1030) Front (09407-1040) Rear 1. Clean the edges and surface of the crank shaft and the special tools. 2. Insert a new crank shaft oil seal into the guide of the oil seal press. NOTE: Pay attention to the orientation of the crank shaft oil seal (The felt side should face the outside of the cylinder block). GUIDE NEW OIL SEAL SM3-J122 Fig. 27 EDGE OF THE CRANK SHAFT FELT SIDE OF THE OIL SEAL GUIDE BOLT GUIDE SM3-J806 Fig. 28 3. Apply a little engine oil to the seal portion of the crank shaft oil seal. 4.
Attach the oil seal press guide with the new crank shaft oil seal onto the crank shaft using the attached guide bolt. GUIDE BOLTS SM3-J123 Fig. 29 PRESS 5. Insert the oil seal press by adjusting the oil seal press hole to the guide bolt. 6. Press the crank shaft oil seal inside by attaching the accompanying center bolt onto the oil seal press and tightening it until it stops. CENTER BOLT Fig. 30 SM3-J124