Hino J08C-TP, J08C-TR — CRANKSHAFT FRONT END, OIL PAN, FLYWHEEL AND FLYWHEEL HOUSING

1 page 1 Models J08C-TP and J08C-TR 3-7-10 ENGINE 5. INSTALL THE FLYWHEEL ASSEMBLY. 1. Make sure that there are no burns or dirt on the con- tact surface or in the threaded holes of the crank- shaft or fly-wheel. 2. Insert the special tool onto the crankshaft. Special tool: Guide bar (09481 - 1340) NOTE: Place one guide bar at the collar knock and an- other at the opposite side of the collar knock. 3. Insert the flywheel slowly until it contacts the collar knock to prevent impact on the guide bar. Adjust the position. Then, insert it completely. WARNING The flywheel is heavy. When installing, be careful not to drop it on your feet. 4.

Apply clean engine oil to the threads of the flywheel bolt and the flywheel bolt seat. Be sure to tighten two or three threads provisionally by hand. Then, tighten the flywheel bolts (8) with a low-torque im- pact wrench. 5. Pull out the guide bar and tighten the remaining two fly-wheel bolts provisionally as in step 4. 6. Tighten the flywheel bolts in the order shown in the figure to the specified torque below. Tightening torque: 1,900 kg·cm (137 lb·ft) 7. Loosen all bolts and tighten them again to the speci- fied torque. Tightening torque: 1,900 kg·cm (137 lb·ft) SM3-J127 Fig. 31 TIGHTENING ORDER CRANKSHAFT COLLAR 5 1 8 3 4 6 2 7 Fig. 32 SM3-J128 8.

Measure the sliding surface play of the flywheel. Measure the sliding surface play of the flywheel with a dial gauge. If the play exceeds the service limit, resurface the sliding surface. Service limit: 0.2 mm (0.0079 in.) 0.3 mm (0.0118 in.) for model SG only Fig. 33 SM3-J129 9. Install the pilot bearing. SM3-J525 Fig. 34