Hino J08C-TP, J08C-TR — CRANKSHAFT FRONT END, OIL PAN, FLYWHEEL AND FLYWHEEL HOUSING

1 page 1 Models J08C-TP and J08C-TR ENGINE 3-7-11 6. INSTALL THE OIL PAN. 1. Make sure that there is no deformation, impact marks or foreign particles on the mounting sur- face and stiffener surface of the oil pan. 2. Place a guide pin of 70 mm(2.7559 in.) or longer in the cylinder block. 3. Apply liquid gasket to the front and back ends of the cylinder block lower surface. Liquid gasket: ThreeBond No.1207B Coating width: 1.5 - 2.5 mm (0.06 - 0.10 in.) 4. Install the oil pan gasket so that the protrusion is at the flywheel housing side and the print seal surface is at the cylinder block side. 5. Install the oil pan. NOTE: LIQUID GASKET (TWO PARTS EACH) SM3-J662 Fig.

35 BOLT TIGHTENING DIRECTION e r w q G Install the oil pan along the guide pin. G If left more than 20 minutes, clean off the liquid gasket completely and reapply the liquid gasket. G Refer to page 3-20-1. 6. Tighten the oil pan installation bolts in the order q - w - e - r as shown in the figure with an impact wrench. Tightening torque: 250 - 300 kg·cm (18 - 21 lb·ft) REAR LOBE OIL STRAINER INTAKE PORT SIDE SM3-J112 Fig. 36 7. Finish tightening the bolts in the order shown in the figure with a torque wrench to the specified torque. Tightening torque: 300 kg·cm (22 lb·ft) NOTE: Make sure that the washer is not on the flange. 7. INSTALL THE FLYWHEEL HOUSING STAYS. Fig. 37 SM3-J663