1 page 1 Models J08C-TP and J08C-TR 3-8-4 ENGINE INSPECTION AND REPAIR INSPECT THE GEAR TEETH FOR PITTING OR WEAR. Visually check the gears for pitting or wear. If a gear is damaged, replace the gear. SM3-J526 Fig. 10 MEASURE THE CLEARANCE BETWEEN THE IDLER GEAR BUSHING AND SHAFT. 1. Using a micrometer, measure the outside diameter of the main idler gear shaft. If the diameter exceeds the service limit, replace the main idler gear shaft. Nominal dimension: 57.0 mm (2.2441 in.) Service limit: 56.94 mm (2.2417 in.) – 0.03 – 0.06 – 0.0012 – 0.0024 SM3-J672 Fig. 11 2. Using a cylinder gauge, measure the inside diam- eter of the main idler gear bushing. 3.
Calculate the clearance from the above measure- ment. If the clearance exceeds the repair limit, replace the main idler gear shaft and/or main idler gear bushing. Assembly standard: 0.030 - 0.090 mm (0.0012 - 0.0035 in.) Repair limit: 0.20 mm (0.0079 in.) Fig. 12 SM3-J673 END PLAY MEASURE THE IDLER GEAR END PLAY OF THE MAIN IDLER GEAR. Using a dial gauge, measure the clearance between the main idler gear and thrust bearing. If the clearance ex- ceeds the repair limit, replace the thrust bearing. Assembly standard: 0.114 - 0.160 mm (0.0045 - 0.0062 in.) Repair limit: 0.20 mm (0.0079 in.) THRUST BEARING CYLINDER BLOCK Fig.
13 SM3-J674 MEASURE THE CLEARANCE BETWEEN THE SUB IDLER GEAR SHAFT AND SUB IDLER GEAR BUSHING. 1. Using a micrometer, measure the outside diameter of the sub idler gear shaft. If the diameter exceeds the service limit, replace the sub idler gear shaft. Nominal dimension: 50.0 mm (1.969 in.) Service limit: 49.95 mm (1.967 in.) – 0.025 – 0.05 – 0.0010 – 0.0020 Fig. 14 SM3-J142