1 page 1 Models J08C-TP and J08C-TR ENGINE 3-8-5 2. Using a cylinder gauge, measure the inside diam- eter of the sub idler gear bushing. If the diameter exceeds the service limit, replace the sub idler gear. Nominal dimension: 50.0 mm (1.969 in.) Service limit: 50.03 mm (1.970 in.) 3. Calculate the clearance from the above measure- ment. If the clearance exceeds the repair limit, replace the sub idler gear shaft and/or sub idler gear bushing. Assembly standard: 0.025 - 0.075 mm (0.0010 - 0.0029 in.) Repair limit: 0.20 mm (0.0079 in.) + 0.03 + 0 + 0.0012 + 0 SM3-J634 Fig. 15 END PLAY MEASURE THE IDLER GEAR END PLAY OF THE SUB IDLER GEAR.
Using a dial gauge, measure the clearance between the sub idler gear and thrust bearing. If the clearance exceeds the repair limit, replace the thrust bearing. Assembly standard: 0.040 - 0.095 mm (0.0016 - 0.0037 in.) Repair limit: 0.30 mm (0.0118 in.) THRUST BEARING CYLINDER BLOCK SM3-J676 Fig. 16