1 page 1 Models J08C-TP and J08C-TR 3-8-6 ENGINE MOUNTING 1. INSTALL THE REAR END PLATE. 1. Using the special tool, tighten two torx bolts adja- cent to the air compressor mounting section to the specified torque below. Special tool: Socket wrench (09411 - 1300) Tightening torque: 560 kg·cm (41 lb·ft) SM3-J135 Fig. 17 2. Tighten the three bolts shown in the figure to the specified torque below. Tightening torque: 560 kg·cm (41 lb·ft) THREE BOLTS SM3-J671 Fig. 18 2. INSTALL THE OIL PUMP ASSEMBLY. 1. Apply oil to the pump case and bearings of the block (hatched area) before installing the oil pump. NOTE:
Not applying oil may cause oil suction failure at start-up, resulting in seizure and abnormality. 2. To prevent misalignment of the gasket, apply grease to the gasket matching face of the block. Then, place and fix the gasket. 3. Tighten the oil pump mounting bolts provisionally in the order as shown in the figure. Then retighten them to the specified torque below. Tightening torque: 290 kg·cm (21 lb·ft) APPLY THE OIL (HATCHED AREA) r SM3-J164 Fig. 19