1 page 1 Models J08C-TP and J08C-TR ENGINE 3-8-7 THRUST PLATE CAMSHAFT GEAR INJECTION PUMP DRIVE GEAR CYLINDER BLOCK C-C SECTION OIL HOLE CAM IDLER GEAR SM3-J137 SUB IDLER GEAR OIL PUMP GEAR THRUST PLATE MAIN IDLER GEAR CRANKSHAFT GEAR OIL HOLE CYLINDER BLOCK B-B SECTION SM3-J138 THRUST PLATE MATCH MARKS “2” MATCH MARKS “1” OIL HOLE CYLINDER BLOCK A-A SECTION SM3-J1369 SM3-J136 Fig. 20 3. INSTALL THE SUB IDLER GEAR. 1. Install the sub idler gear shaft through the thrust plate so that the lubrication hole faces downward. 2. Install the sub idler gear. 3. Tighten the mounting bolts of the sub idler gear shaft to the specified torque below. Tightening torque:
1,100 kg·cm (80 lb·ft) SM3-J678 Fig. 21 4. INSTALL THE MAIN IDLER GEAR. 1. Install the main idler gear shaft through the thrust plate so that the lubrication hole faces downward. 2. Install the main idler gear. NOTE: G Apply engine oil to the contact surface of the idler gear and idler gear shaft before installation. G Adjust the timing of the main idle gear to align with the injection pump gear (air compressor gear). SM3-J679 Fig. 22