1 page 1 Models J08C-TP and J08C-TR ENGINE 3-9-3 DISMOUNTING 1. REMOVE THE PISTONS ALONG WITH THE CONNECT- ING RODS. Remove the connecting rod bearing cap mounting bolts and pull out the pistons along with the connecting rods from the cylinder block upper side. NOTE: SM3-J154 G Before pulling out the pistons, remove carbon deposits from the upper end inside the cylinder liner with a scraper or emery paper (recommended: No. 150), working in a circular direction. G When pulling out the pistons, be careful that the in- sides of the cylinder liners are not damaged by the connecting rod big ends.
G When pulling out the pistons, be careful that the noz- zle of the cooling jet is not bent by the connecting rod big ends. If the nozzle is bent, be sure to readjust the cooling jet sight. G When pulling out the pistons, be careful not to drop the crankpin bearings from the connecting rod big ends, which may cause deformation or damage. G Arrange the removed parts in order of the cylinder numbers. Be careful not to change the combination of the connecting rod and cap. G Two pistons can be removed at a time. (Nos. 1 and 6, Nos. 2 and 5, and Nos. 3 and 4). Fig. 3 SM3-J680 Fig. 4 SM3-J681 2. REMOVE THE CRANKSHAFT. Remove the main bearing cap mounting bolts, then re- move the crankshaft. Fig.
5 Fig. 6 SM3-J682 3. REMOVE THE CYLINDER LINER. NOTE: Before removing the piston, put alignment marks on the cylinder liner and cylinder block using a marking pen. The cylinder liner is bent by “run- in”. When reusing the cylinder liner, misalignment with the cylinder block may concentrate stress on the thin part of the cylinder liner and it may break. Fig. 7 SM3-J157