1 page 1 Models J08C-TP and J08C-TR 3-9-4 ENGINE 1. The cylinder liner can be pulled out by hand. If this is difficult, use the special tool. NOTE: Arrange the removed parts in order of the cylin- der numbers. SM3-J683 Fig. 8 4. CLEAN THE CYLINDER BLOCK AS FOLLOWS. 1. Rinse the cylinder block in a hot commercial alka- line solution, and remove oil from the cylinder block. 2. Remove the alkaline solution from the cylinder block using a steam cleaner. 3. If the water jacket is very dirty, clean it as follows: a. Rinse the cylinder block in a commercial acid solu- tion. b. After rinsing it for a while, leave it in the solution for approximately 30 minutes. c. Pull out the cylinder block.
After the solution has drained off, re-immerse the cylinder block in the so- lution and leave it for approximately 10 minutes. d. Repeat step c until deposits are removed. e. Remove the acid solution with hot water. f . Immerse the cylinder block in the alkaline solution to neutralize the acid. g. Finish by cleaning with the steam cleaner. 4. When the cooling water passage and oil passage are cleaned completely, dry the cylinder block, press-fit a new blank cap and apply liquid gasket.