1 page 1 Models J08C-TP and J08C-TR ENGINE 3-9-5 DISASSEMBLING REMOVE THE CONNECTING ROD. 1. Remove the retainer rings from both ends of the pis- ton pin using snap ring pliers. WARNING Removing the retainer rings may cause the retainer rings to fly up. Be sure to wear protective goggles. SM3-J684 Fig. 9 2. Apply the reinforcing plate to the piston pin and punch out the piston pin using a hammer. WARNING Never touch the piston with your bare hands when it is hot. NOTE: If it is difficult to punch out the piston pin, first immerse the piston and piston pin in hot water, 80 - 90°C (176 - 194°F), for approximately five min- utes to facilitate removal. REMOVE THE PISTON RINGS. 1.
Remove the piston ring using the special tool. Special tool: Piston ring expander (09442 - 1011) NOTE: G Handle the piston rings carefully because they are made of a special casting which is easily broken. G Arrange the piston rings in order of cylinder numbers. Fig. 10 SM3-J685