1 page 1 Models J08C-TP and J08C-TR 3-9-6 ENGINE INSPECTION AND REPAIR INSPECT THE CONNECTING ROD. 1. Check the connecting rod for cracks or damage us- ing dye penetrant examination or magnetic particle examination. If there are any cracks or damage, re- place the connecting rod with a new one. 2. Check that there is no clogging in the lubrication passage to the connecting rod small end. If there is any clogging, blow air through the lubrication pas- sage using an air gun, or clean by inserting a wire. 3. Measure bend or distortion of the connecting rod using a connecting rod aligner. If the value exceeds the limit, replace the connecting rod with a new one. Limit: Bend of connecting rod:
0.05 mm (0.0020 in.) for each 100 mm (3.94 in.) Distortion of connecting rod: 0.05 mm (0.0020 in.) for each 100 mm (3.94 in.) INSPECT THE PISTON PIN AND CONNECTING ROD BUSHING. 1. Measure the piston pin outside diameter using a micrometer. If the value exceeds the limit, replace the piston pin with a new one. NOTE: Never grind the piston pin because the surface is treated. Standard: 37 mm (1.4567 in.) Limit: 36.96 mm (1.4551 in.) 2. Measure the connecting rod bushing inside diameter using a cylinder gauge. If the value exceeds the limit, replace the connecting rod bushing with a new one. Standard: 37 mm (1.4567 in.) Limit: 37.1 mm (1.4606 in.) 3.
Calculate the clearance between the piston pin and piston pin bushing. If the value exceeds the limit, replace the piston pin with a new one. Standard: 0.015 - 0.036 mm (0.0006 - 0.0014 in.) Limit: 0.08 mm (0.0031 in.) Fig. 15 SM3-J255 Fig. 11 SM3-J242 Fig. 12 SM3-J527A SM3-J527 Fig. 13 SM3-J303 Fig. 14 SM3-J254