1 page 1 Models J08C-TP and J08C-TR ENGINE 3-9-7 REPLACE THE PISTON PIN BUSHING. 1. Prepare the special tools. Assemble the guide and press sub-assembly insert- ing its pin into the guide then secure them with the wing nut. Special tool: Guide (09481 - 1130) Press sub - assembly (09402 - 1530) Wing nut (9233 - 10360) NOTE: WING NUT GUIDE PIN PRESS SUB ASSEMBLY SM3-J466 Fig. 16 G Bring lever “H” punched on the guide above the pin. G Making sure to align both supporting surfaces of the guide and press sub-assembly flush on a flat plane. 2. Using the special tool, remove the piston pin bush- ing. a.
Set the connecting rod assembled without crank pin bore bearing on the guide and press sub-assembly. CONNECTING ROD GUIDE PRESS SUB ASSEMBLY SM3-J467 Fig. 17 GROOVE SPINDLE b. Install the spindle into the bushing. Special tool: Spindle (09402 - 1540) NOTE: Align the grooving of the spindle with the oil hole of the bushing. BUSHING CONNECTING OIL HOLE ROD PRESS SUB ASSEMBLY SM3-J468 Fig. 18 PRESS c. Using a hydraulic press, remove the bushing. NOTE: Always operate the press slowly and smoothly. SPINDLE CONNECTING ROD Fig. 19 SM3-J469 3. Assemble the piston pin bushing.
Chamfer one edge of the bushing hole at the small end of the connecting rod uniformly by C 0.5 - 1.0 mm (0.0196 - 0.0393 in.). NOTE: C 0.5 - 1.0 mm G Irregular chamfering can cause out-of-roundness of the pressed bushing, which may result in jamming during insertion. G Remove dust from the inner surface of the smaller hole. CONNECTING ROD Fig. 20 SM3-J470