1 page 1 Models J08C-TP and J08C-TR 3-9-8 ENGINE 4. Mount the bushing on the spindle a. Set the bushing and guide on the spindle, then se- cure them with the bolt. Special tool: Spindle (09402 - 1540) Guide (09481 - 1540) Bolt (9191 - 08252) NOTE: Align oil hole (A) in the bushing with both groove or the spindle and guide, making sure oil hole (B) will meet with oil path in the connecting rod led from crank pin bore in the rod. Tightening torque: 50 - 70 kg·cm (3.61 - 5.06 lb·ft) b. Apply fresh engine oil around the bushing and guide. 5. Install the bushing in the connecting rod. Position the bushing tool assembly so that oil hole (B) align with the oil path through the connecting rod.
Before installing, fully coat the bore in the con- necting rod with fresh engine oil. SPINDLE GROOVE OIL HOLE (B) OIL HOLE (A) GUIDE BUSHING BOLT GROOVE GUIDE SM3-J471 Fig. 21 PRESS OIL HOLE (B) SPINDLE BUSHING OIL PATH GUIDE CONNECTING ROD SM3-J472 Fig. 22 6. Inspect the bushing positioning after installation. a. Make sure that the oil hole of the bushing and the oil path of the connecting rod are suitably aligned al- lowing a 6 mm (0.23 in.) diameter rod to penetrate. NOTE: Misalignment can lead to insufficient lubrication, which may result in seizure. b. Make sure that with a new piston pin inserted in the piston pin, the bushing can be rotated by hand without rattling. SM3-J242 Fig. 23