1 page 1 Models J08C-TP and J08C-TR 3-9-10 ENGINE 2. Measure the connecting rod bearing inside diameter using a cylinder gauge. Standard: 65 mm (2.559 in.) 3. Calculate the clearance between the crankpin and connecting rod bearing. If the value exceeds the limit, grind the crankpin to the specified undersize below to correct. Replace the connecting rod bearing with the correct one. Standard: 0.031 - 0.082 mm (0.0012 - 0.0032 in.) Limit: 0.2 mm (0.0079 in.) Undersize machining dimension: Two sizes below 0.25 mm (0.0098 in.), 0.50 mm (0.0197 in.) NOTE: Make sure you replace the top and bottom con- necting rod bearings as one set.
The top and bot- tom connecting rod bearings must be profiled by roundness. SM3-J527 Fig. 28 SM3-J528 Fig. 29 MEASURE THE CLEARANCE BETWEEN THE PISTON AND THE CYLINDER LINER. NOTE: Before measurement, remove carbon deposits from the upper end inside the cylinder liner with a scraper or emery paper (recommended: No. 150), working in a circular direction. Make sure that there are no scratches inside the cylinder liner. SM3-J154 Fig. 30 1. Measure the piston outside diameter at the follow- ing points using a micrometer. If the value exceeds the limit, replace the piston with a new one. Standard: 114 mm (4.4882 in.) Limit: 113.92 mm (4.4850 in.) Fig.
31 SM3-J530 OUTSIDE DIAMETER 21 mm (0.83 in.) Fig. 32 SM3-J540