Hino J08C-TP, J08C-TR — PISTON, CRANKSHAFT AND CYLINDER BLOCK

1 page 1 Models J08C-TP and J08C-TR ENGINE 3-9-11 2. Measure the cylinder liner inside diameter at the four points in the piston boss and thrust direction as shown in the figure using a cylinder gauge. If the value exceeds the limit, replace the cylinder liner with a new one. Standard: 114 mm (4.4882 in.) Limit: 114.15 mm (4.4941 in.) NOTE: SM3-J544 G Apply the value obtained at the most worn point to the cylinder liner inside diameter. G If the cylinder liner is hardly worn, and when only the piston ring must be replaced, correct the corrugation at the top of cylinder liner. 3. Measure the clearance between the piston and cyl- inder liner.

If the value exceeds the limit, replace the cylinder liner with a new one. NOTE: Apply the value obtained at the most worn point to the cylinder liner inside diameter. Standard: 0.056 - 0.088 mm (0.0022 - 0.0034 in.) Limit: 0.15 mm (0.0059 in.) Fig. 33 20 (0.79) 40 (1.57) 80 (3.15) 160 (6.30) X Y Unit: mm (in.) SM3-J251 Fig. 34 MEASURE THE CLEARANCE BETWEEN THE PISTON PIN AND THE PISTON PIN BOSS. 1. Measure the piston pin outside diameter using a micrometer. If the value exceeds the limit, replace the piston pin with a new one. Standard: 37 mm (1.4567 in.) Limit: 36.96 mm (1.4551 in.) Fig. 35 SM3-J303 2. Measure the piston pin boss inside diameter using a cylinder gauge.

If the value exceeds the limit, replace the piston with a new one. Standard: 37 mm (1.4567 in.) Limit: 37.05 mm (1.4587 in.) 3. Calculate the clearance between the piston pin and the piston pin boss. If the value exceeds the limit, replace the piston or piston pin. Standard: -0.013T - 0.014L mm (-0.00051T - 0.00055L in.) Limit: 0.05 mm (0.0019 in.) NOTE: T = tightening allowance, L = clearance Fig. 36 SM3-J541