Komatsu — SPEED CONTROL LEVER

Remark The length of the lever can be adjusted to 3 stages (positions A, B, C). To adjust the length, remove the screw at the bottom of the lever knob, slide the knob to the desired position, then tighten the screw again. The lever is installed to position B when it is shipped from the factory. OPERATION AUTOMATIC SHIFT Automatic gear shifting can be performed in the 2nd and 4th speed range of the four forward and reverse speeds depending on the travel conditions. Position (a): 1st Position (b): 2nd Position (c): 3rd Position (d):

4th (disabled for Waste Handler machine) The range of speeds during automatic gear shifting is determined by the position of the gear shift lever as shown in the chart on the right. Remark The 1st position for the gearshift lever sets the transmission in 1st. There is no automatic shifting of the transmission. When shifting down from 2nd to 1st, press the kick-down switch on the lift arm control lever. If the transmission is in auto-shift and the travel speed is below 12.5 km/h (7.8 mph) in any speed range when traveling in either forward or in reverse, the kick-down switch is actuated and makes it possible to shift down to 1st. This makes it easy to perform load and carry operations.

Even if the travel speed is more than 12.5 km/h (7.8 mph), this switch can be used to shift the transmission down. Each time the kick-down switch is pressed, the speed range will shift down one range at a time (when in 4th: F4 F3 F2; when in 3rd: F3 F2). WA480-5L 2-61