Komatsu — SPEED CONTROL LEVER STOPPER

OPERATION To set to the desired speed range when traveling uphill or downhill, or when grading, do as follows. When setting the speed range, press the HOLD switch on the lift arm control lever. The speed range is setting at the speed range displayed on the transmission indicator on the main monitor. When shifting up or down from set speed range, use the gear shift lever to shift gears. Remark When downshifting the transmission from 2nd to 1st with the kickdown switch, an upshift from 1st to 2nd occurs when travel speed increases. DIRECTIONAL LEVER This lever (2) is used to change the direction of travel of the machine.

The engine cannot be started if the directional lever is not at N (neutral). In this case, the central warning lamp will light up and the buzzer will sound. At the same time, “E00 SHIFT LEVER NEUT” is displayed on the character display. Return the gearshift lever to the N position and start the engine. Position (a): Forward Position N: Neutral Position (b): Reverse Remark The length of the lever can be adjusted to 3 stages (positions A, B, C). To adjust the length, remove the screw at the bottom of the lever knob, slide the knob to the desired position, then tighten the screw again.

(The lever is installed to position B when it is shipped from the factory.) SPEED CONTROL LEVER STOPPER This stopper (3) prevents the speed control lever from entering the 3rd and 4th positions when working. Position (a): Stopper actuated. Position (b): Stopper released. 2-62 WA480-5L