Komatsu — BACKUP WARNING ALARM

SAFETY FEATURES OPERATION Before performing any type of operation or maintenance on the machine it is important to know where and how to use the safety features built into the machine. These safety features are of the passive type or active type. PASSIVE SAFETY FEATURES Passive safety features are built into the machine and need little or no attention. It is important to inspect these safety features for damage or ware occasionally. ROLL-OVER PROTECTIVE STRUCTURE (ROPS) This is to protect the operator in a rollover situation or from falling objects.

When operating the machine, it is important to remain within the ROPS structure to avoid any contact with falling objects Never modify, cut or drill on any part of this structure. Doing so may weaken the structure which could lead to possible failure in a rollover situation. CAB FRONTAL GUARD (WASTE HANDLER APPLICATION ONLY) This feature is only available on the waste handler machines. It is designed to protect the operator from objects falling back onto the cab and entering the operators compartment. When using this machine in waste handler applications do not remove or modify this protective cage. If it is damaged, replace it.

BACKUP WARNING ALARM This sounds an alarm when the directional lever is set to the R position. It is used to warn people behind the machine that the machine will travel in reverse. If the alarm cannot be heard clearly or is too loud, adjust the volume as follows. Remark The alarm is set to the highest level when the machine is shipped from the factory. CHANGING ALARM VOLUME Operate the sound pressure selector switch at the rear face of the backup alarm to adjust the volume. WA480-5L 2-69