OPERATION Standard type Adjustments (E), (J), and (K) use the air compressor built into the seat, so turn the engine ignition switch to the “ON” position when carrying out the adjustment. A. Fore-and-aft adjustment: Pull lever (1) up, set the seat to the desired position, then release the lever.Amount of adjustment: 180 mm (7.1 in.) (10 mm (0.4 in.) x 18 stages) B. Seat angle adjustment: Move lever (2) up and apply your weight to the rear of the seat. The seat will tilt to the rear. Move lever (3) up and apply your weight to the front of the seat. The seat will tilt to the front. Amount of adjustment: 24 degrees (front and rear tilt: 3 stages each) C. Seat height adjustment:
Move levers (2) and (3) up and move the seat up or down to desired position. These levers are also used for adjusting the seat angle, so adjust the seat angle to set the seat to the desired height. Amount of adjustment: 65 mm (2.6 in.) D. Adjusting fore-and-aft position of seat cushion: Push lever (4) in, set the seat cushion to the desired position, then release lever. Amount of adjustment: 65 mm (2.6 in.) E. Adjusting weight setting for seat: Sit on the seat, raise your body slightly, then operate switch (5) to adjust the strength of the suspension. Amount of adjustment: 50 - 130 kg (110 - 287 lb.)(target) When + is pressed: Suspension becomes stronger When - is pressed:
Suspension becomes weaker F. Reclining angle adjustment: Move lever (6) up and move the seat backrest to the front or rear. Push your back against the backrest when carrying out this adjustment. If your back is not pressing against the backrest, the backrest may suddenly spring forward. Amount of adjustment: Front tilt: Free Rear tilt:40 degrees (2 degrees x 20 stages) G. Head rest angle adjustment (if equipped): Rotate the headrest to the front or rear. Amount of adjustment: Front tilt: 13 degrees Rear tilt: 13 degrees H. Head rest height adjustment Move the head rest up or down. Amount of adjustment: 80 mm (3.2 in.) I. Arm rest angle adjustment:
Rotate the knob (7) and adjust the angle of the arm rest. (Left side only) Amount of adjustment: 73 degrees (front: 54 degrees; rear: 19 degrees) If the arm rest is turned, it will spring up. (Both left and right sides) J. Lumbar support Operate switch (8) to give a suitable tension to the lower lumbar region. Operate switch (9) to give a suitable tension to the upper lumbar region. When + is pressed: Tension becomes stronger When - is pressed: Tension becomes weaker K. Side support: Operate switch (10) to give a suitable tension to the left and right lumbar region. When + is pressed: Tension becomes stronger When - is pressed: Tension becomes weaker 2-76 WA480-5L