Komatsu — SEAT BELT ADJUSTMENT

OPERATION IN THE OPERATOR’S CAB A. Check the condition of the cab floor. Be sure it is clean and free from tools, objects, excess dirt, trash or grease. B. Check to be sure both doors open and close properly. Be sure the right door is unlocked for safety purpose. C. Check the windows for cleanliness, remove any stickers or objects pasted to the windows. D. Make sure the fire extinguisher is in place and in operating condition. E. Be sure the operator’s manual, safety manual and all cab safety decals are in place and in good condition. F. Check to be sure the seat belt and seat works properly. SEAT BELT ADJUSTMENT Always wear the seat belt.

Before fastening the seat belt, check that there is no abnormality in the belt mounting bracket or bolt. If the belt is worn or damaged, replace it. Fasten the seat belt before starting operations. Always wear the seat belt during operations. Make sure that the left and right belts are not twisted when fastening the seat belt. Fastening and removing the belt 1. Fasten the belt so that it is snug without being too tight. Sit on the seat, depress the brake pedal fully, and adjust the seat so that your back is pressed against the backrest. 2. After adjusting the seat position, adjust tether belt (1). Tense the tether belt and install it when there is no one sitting on the seat. 3.

Sit on the seat, hold buckle (2) and tongue (3) with your left and right hands, insert tongue (3) into buckle (2), then pull the belt to check that it is securely locked. 4. When removing the belt, press the red button in buckle (2) to free the belt. Fasten the belt along your body without kinking it. Adjust the lengths of the belt on both the buckle and the tongue sides so that the buckle is located at the mid-point of your body front. Belt length adjustment To make the belt shorter: Pull the free end if the tether belt. WA480-5L 2-81