OPERATION CHECK ENGINE OIL LEVEL, ADD OIL The parts and oil are at high temperature immediately after the engine is stopped, and may cause serious burns. Wait for the temperature to go down before starting the operation. 1. Open the inspection cover of the right side at the rear of the machine. 2. Take out the dipstick (G) and wipe off the oil with cloth. 3. Insert dipstick (G) fully in the oil filler pipe, then take it out again. 4. The oil level should be between the H and L marks on dipstick (G). 5. If the oil level is below the L mark, add engine oil through oil filler (F). 6. If the oil is above the H mark, drain the excess engine oil from drain plug (P), and check the oil level again.
7. If the oil level is correct, tighten oil filler cap (F) securely and close the inspection cover. Remark When checking the oil level after the engine has been oper- ated, wait for at least 15 minutes after stopping the engine before checking. If the machine is at an angle, make it horizontal before checking. REAR-VIEW MIRROR ADJUSTMENT Sit in the operator's seat and adjust the rear view mirror so that you can see properly to the rear. 2-80 WA480-5L