Komatsu — STARTING THE ENGINE

OPERATION 1. With the key to the “ON” position. Preheating will automatically start and preheating pilot lamp (2) will light up. The table shown below gives a guide to preheating time.(sec) The preheating time in cold areas changes according to the water temperature when starting the engine. 2. Depress accelerator pedal (3) lightly. 3. When preheating pilot lamp (2) goes out, turn the key in ignition switch to the “START” position. The starting motor will be cranked and after the engine rotates under no load for 2 or 3 seconds, the engine should start. Do not accelerate the engine suddenly before the warm-up operation is completed.

Do not crank the starting motor continuously for more than 20 seconds. If the engine does not start, wait for at least two minutes before trying again. If the accelerator pedal is kept pressed after the engine is started, the engine speed will rise suddenly after the turbo protect time, and this may damage the turbocharger. 2-86 WA480-5L