Komatsu — STOPPING THE ENGINE

2. To warm up the hydraulic oil only in cold areas, do as follows. During the warming-up operation, check that the engine rotation is smooth, then set the safety lock of the work equipment control lever to the FREE position and move the bucket control lever in and out of the TILT position to warm up the hydraulic oil. The relief time at the tilt position should be a maximum of 10 seconds.With this operation, the oil will reach the relief pressure and this will warm up the hydraulic oil more quickly OPERATION 3. After performing the warm-up operation, check that the gauges and caution lamps are normal. If there is any abnormality, perform maintenance or repair.

Run the engine under a light load until engine water temperature gauge (2) and torque converter oil gauge (3) are in the green range. 4. Check that there is no abnormal exhaust gas color, noise, or vibration. If any abnormality is found, contact your Komatsu distributor. Remark The sound of the cooling fan rotation differs according to the following conditions, but this does not indicate any abnormality. The cooling fan speed increases when the hydraulic oil temperature, engine coolant temperature, or transmission oil temperature are high.

However, when the cooling fan is rotating in reverse, it rotates at a set speed proportional to the engine speed, regardless of any oil or coolant temperature. STOPPING THE ENGINE Remark If the engine is abruptly stopped before it has cooled down, engine life may be greatly shortened. Consequently, do not abruptly stop the engine apart from an emergency. In particular, if the engine has overheated, do not abruptly stop it but run it at medium speed to allow it to cool gradually, then stop it. 1. Run the engine at low idling for about 5 minutes to cool down grad- ually. 2. Turn the ignition switch (1) to the “OFF” position to stop the engine. 3. Remove the key from ignition switch (1).

After Stopping The Engine 4. Walk around the machine and check the work equipment, body and undercarriage check for leakage of oil and coolant. 5. Fill the fuel tank. 6. Check the engine compartment for paper and debris. Clean out any paper and debris to avoid a fire hazard. 7. Remove any mud attached to the undercarriage. WA480-5L 2-89