Komatsu — NORMAL START-UP AND WARM-UP

OPERATION OPERATIONS AND CHECKS AFTER STARTING ENGINE If any problems occur, turn the ignition switch to the “OFF” position. If the work equipment is operated without warming up the machine sufficiently, the response of the work equipment to the movement of the control lever will be slow, and the work equipment may not move as the operator desires, so always perform the warm-up operation. Particularly in cold areas, be sure to perform the warm-up operation fully. BREAKING IN THE MACHINE Your Komatsu machine has been thoroughly adjusted and tested before shipment.

However, operating the machine under severe conditions at the beginning can adversely affect the performance and shorten the machine life. Be sure to break-in the machine for the initial 100 hours (as indicated by the service meter). During break-in operations, follow the precautions described in this manual. Idle the engine for 5 minutes after starting it up. Avoid operation with heavy loads or at high speeds. Avoid sudden starts, sudden acceleration, sudden steering and sudden stops except in cases of emergency. NORMAL START-UP AND WARM-UP After starting the engine, do not immediately start operations. First, perform the following operations and checks.

Remark Do not suddenly accelerate the engine before the warm-up operation is completed. Do not run the engine at low or high idle continuously for more than 20 minutes. If it is necessary to run the engine at idle, apply a load from time to time or run the engine at a midrange speed. 1. Depress the accelerator pedal (1) lightly and run the engine with no load at midrange speed for about 5 minutes. 2-88 WA480-5L