Komatsu — CHANGING GEAR SPEED RANGES

OPERATION When traveling, and turning the machine. Keep in mind the front frame is joined to the rear frame at the center of the machine by the center pin. Therefore, the front and rear frames bend at this point, and the rear wheels follow in the same track as the front wheels when turning. When turning, turn the steering wheel carefully to follow the machine as it turns. Remark When the steering wheel reaches the end of its stroke, do not try to turn it any further. Check the play it should be 50 to 100 mm (2.0 to 3.9 in) in the steering wheel. If any abnormality is found, contact your Komatsu dealer for inspection. TURNING ON SLOPES Traveling on slopes is dangerous in general.

However, turning on a slope can be fatal. When traveling on a slope never turn the steering wheel. Always travel straight up or straight down a slope. If the machine should start to tip, lower the bucket to the ground immediately to stabilize the machine. Travel at a slow pace in the lower speed ranges, avoid dragging the brakes when traveling down a slope. Remark When starting to move the machine on a hill, turn transmission cut-off switch (1) “OFF”, depress left brake pedal (2), operate the gearshift lever to the travel position, then depress accelerator pedal (3) and gradually release left brake pedal (2) to let the machine move.

This makes it possi- ble to prevent the machine from rolling back. CHANGING GEAR SPEED RANGES When traveling at high speed, do not shift gears suddenly. Use the brake to reduce the travel speed before shifting gears. 2-92 WA480-5L