Shift Gears As Follows. Move the gearshift lever (1) to the desired position to shift. OPERATION When digging or loading, perform the operation in 1st or 2nd. Use the gearshift lever stopper. Remark This machine is equipped with the kick-down switch. When the machine is traveling in 2nd, press the button on the tip of the lift arm control lever to downshift to 1st. We recommend use of the kick-down switch when carrying out operations in 1st or 2nd, such as digging or loading. For details of the method of use, see “KICKDOWN SWITCH” on page 2-38. This machine is equipped with an auto-shift system that automatically shifts the gear.
For details of the method of use, see “TRANSMISSION MODE SELECTOR SWITCH” on page 2-34 and ““AUTOMATIC SHIFT” on page 2-61. If the gearshift lever is operated slowly or is stopped between gear positions, “E01 MAINTENANCE” may be displayed on the character display. In this case, there is no failure, but try to operate the gearshift lever so that the gearshifts is completed within 2 seconds. CHANGING DIRECTION When changing direction between FORWARD and REVERSE, check that the new direction of travel is safe. There is a blind spot behind the machine, so be particularly careful when changing direction to travel in reverse. Do not switch between FORWARD and REVERSE when traveling at high speed.
When switching between FORWARD and REVERSE, depress the brake to reduce the travel speed sufficiently, then change the direction of travel. (Max.speed for changing direction: 12 km/h (7.5 mph)) There is no need to stop the machine even when switching between FORWARD and REVERSE. Place the directional lever (1) in the desired position. Remark The directional selector switch makes it possible to change the direction of travel by operating a switch. WA480-5L 2-93