Komatsu — USING THE SWITCH TO CHANGE DIRECTION

OPERATION If an attempt is made to switch the direction between forward and reverse while traveling at high speed (when using 3rd or 4th), if the travel speed and engine speed are in ranges I or II in the chart on the right, the central warning lamp will light up and the buzzer will sound. At the same time, “E00 OVERRUN PROTECT” is displayed on the character display. If the alarm buzzer sounds, depress the brake immediately to reduce the travel speed, then operate the directional lever to switch between forward and reverse.

WHEN USING AUTO-SHIFT If an attempt is made to switch the direction between forward and reverse when the auto-shift is “ON”, the gearshift range will normally switch F3 R2, F4 R2, or R3 F2, R4 F2 to make the machine move quickly. However, if an attempt is made to shift between forward and reverse when the machine is traveling at high speed, as shown in ranges I or II in the chart on the right, the central warning lamp will light up and the buzzer will sound. Simultaneously, “E00 OVERRUN PROTECT” displays. If the alarm buzzer sounds, depress the brake immediately to reduce the travel speed, then operate the directional lever to switch between forward and reverse.

In particular, if you attempt to switch between forward and reverse in range II, the gearshift range will not shift to 2nd, but will switch F3 R3, F4 R4, or R3 F3, R4 F4. As a result, the reduction in travel speed will be less than in range I, so care is necessary. Remark If the gearshift lever is operated slowly or is stopped midway between the forward and reverse directions, “E01 MAINTENANCE” may be displayed on the character display. In this case, there is no failure, but try to operate the directional lever so that the change in direction is completed within 2 seconds. USING THE SWITCH TO CHANGE DIRECTION 1. Place the directional lever at the N position. 2-94 WA480-5L