2. Set the transmission cut-off switch (3) to the “ON” position. 3. Depress left brake pedal (4) and set it to the desired position to shift the transmission to neutral. 4. Press the transmission cut-off set switch (5), then release it. When the switch is released, the buzzer will sound with a repeated short sound, and the cut-off position is set. OPERATION Method of canceling cut-off position 5. After the buzzer sounds in Step 4 of the adjustment procedure, the transmission cut-off switch flashes for 2 seconds. While it is flashing, press transmission cut-off set switch (5) again and release it. 6. The buzzer will sound with a long sound and the adjusted cut-off position is canceled.
STOPPING WHEN TRANSMISSION CUT-OFF IS ON When the transmission cut-off switch is at the “ON” position and the left brake pedal is depressed, the transmission is shifted to neutral at the pre-selected brake pedal depression position. The transmission is not shifted to neutral when the right brake pedal is operated. Remark When the transmission cut-off switch is “OFF”, the left brake pedal acts in the same way as the right brake pedal, and the transmission is not shifted to neutral. TURNING Operating the steering wheel suddenly at high speed or operating the steering wheel on steep slopes is dangerous. Do not operate the steering wheel in such situations.
If the engine stops when the machine is traveling, the emergency steering is actuated. This system is only for steering in emergencies, so never stop the engine. It is particularly dangerous if the engine stops when the machine is traveling on slopes, so never let the engine stop when traveling on slopes. If the engine stops, stop the machine immediately at a safe place. When traveling, use the steering wheel to turn the machine. The center pin joins the front frame to the rear frame. The front and rear frames pivot at the center point, and the rear wheels follow in the same track as the front wheels when turning. Turn the steering wheel lightly to follow the machine as it turns.
Remark When the steering wheel is turned fully, if it reaches the end of its stroke, do not try to turn it further. Check that there is a play of 50 to 100 mm (2.0 to 3.9 in.) in the steering wheel. Check also that the steering works prop- erly. If any abnormality is found, please contact your Komatsu distributor for inspection. WA480-5L 2-99