Komatsu — LOADING PILED SOIL OR BLASTED ROCK

OPERATION SCOOPING A LOAD OR CUTTING A GRADE Never perform digging or scooping operations with the machine articulated because the machine may tip over. The work equipment will move when the travel damper switch is turned “ON” (ECCS), regardless if the machine is traveling or the work equipment is raised. Remark If the tires slip, tire life will be reduced. Do not allow the tires to slip during operation. LOADING PILED SOIL OR BLASTED ROCK When loading piled soil or blasted rock, drive the machine forward (as follows) to load. To prevent the tires from getting cut caused by the tires slipping, be careful of the following points during the operation.

Always keep the operating job site flat, and remove any fallen rocks. When working with stockpiles, operate the machine in 1st or 2nd; when loading blasted rock operate the machine in 1st. 1. When driving the machine forward and lowering the bucket, stop the bucket about 30 cm (12 in.) from the ground, then lower it slowly. Remark If the bucket hits the ground, the front tires will come off the ground and the tires will slip. 2. Downshift immediately in front of the material to be loaded. After downshifting, depress the accelerator pedal at the same time and thrust the bucket into the load. Remark To reduce fuel consumption, depress the accelerator pedal the minimum possible amount.

If it is fully depressed, the fuel consumption will increase, but there will be no increase in the amount loaded. 3. When the material is in a stockpile, keep the cutting edge of the bucket horizontal; when loading blasted rock, have the bucket tilting slightly down. Be careful not to get blasted rock under the bucket. This will make the front tires come off the ground and slip. Try to keep the load in the center of the bucket; if the load is on one side of the bucket, the load will be unbalanced. 2-104 WA480-5L