Komatsu — LOAD AND CARRY OPERATIONS

OPERATION LEVELING OPERATIONS Always operate the machine in reverse when carrying out leveling operations. If it is necessary to perform leveling operations when traveling forward, do not set the bucket dumping angle to more than 20 degrees. Turn the E.C.S.S. OFF carrying out leveling operations. 1. Scoop soil into the bucket. Move the machine backward while spreading soil from the bucket little by little. 2. Go over the spread soil with the bucket teeth touching the ground and level the ground by back-dragging. 3. Scoop some more soil into the bucket, put the lift arm in float, level the bucket at ground level, and smooth the ground by moving backward.

PUSHING OPERATION Never set the bucket to the DUMP position when pushing. When pushing, set the bottom of the bucket parallel to the ground surface. LOAD AND CARRY OPERATIONS When carrying a load, lower the bucket to lower the center of gravity when traveling. Always stop the machine and lower the work equipment to the ground before operating the E.C.S.S. switch. When performing inspection and maintenance, first lower the work equipment to the ground, then turn the E.C.S.S. switch “OFF” before starting the inspection and maintenance operation.

The load and carry method for wheel loaders consists of a cycle of scooping hauling loading (into a hopper, truck, etc.) Always keep the travel path properly maintained. When using the load and carry method, see “LOAD AND CARRY OPERATIONS” on page 2-107. WA480-5L 2-107