Komatsu — PRECAUTIONS WHEN PILING UP LOADS

OPERATION LOADING OPERATIONS Select the method of operation which will give the minimum amount of turning and travel in order to provide the most efficient method for the job site. Always keep the job site flat, and do not operate the steering wheel suddenly or apply the brakes suddenly when the lift arm is raised with a loaded bucket. This action is dangerous. Never thrust the bucket in when traveling at high speed (when loading soil or crushed rock). This action is dangerous. The work equipment will move when the travel damper switch is turned “ON” (ECCS), regardless if the machine is traveling or the work equipment is raised.

CROSS DRIVE LOADING Always set the wheel loader facing at a right angle to the stockpile. After digging in and scooping up the load, drive the machine straight back in reverse, then bring the dump truck in between the stock pile and the wheel loader. This method requires the least time for loading, and is extremely effective in reducing the cycle time. Remark If the tires slip, the life of the tires will be reduced. Do do not allow the tires to slip during operation. Avoid excessive bucket shaking also. V-SHAPE LOADING Position the dump truck so that the direction of approach of the wheel loader is approximately 60 degrees from the direction of approach to the stockpile.

After loading the bucket, drive the wheel loader in reverse, then turn it to face the dump truck and travel forward to load the dump truck. The smaller the turning angle of the wheel loader is, the more efficient the operation becomes. When loading a full bucket and raising it to the maximum height, first shake the bucket to stabilize the load before raising the bucket. This will prevent the load from spilling to the rear. PRECAUTIONS WHEN PILING UP LOADS When forming products into a pile, be careful not to let the rear counterweight come into contact with the ground. Do not set the bucket to the DUMP position when piling-up loads.

Remark When scooping-up, avoid using the transmission cut-off function as much as possible. It will prevent the machine from moving back. When using the transmission cut-off function, adjust the cut-off position to match the amount that the brake pedal is depressed in order to ensure ample braking force. 2-108 WA480-5L