OPERATION PRECAUTIONS WHEN DRIVING THE MACHINE When the machine travels at high speed for a long distance, the tires become extremely hot. This action causes early wear of the tires, so it should be avoided as much as possible. If the machine must be driven for a long distance, take the following precautions. Follow the regulations related to this machine, and drive carefully. Before driving the machine, perform the checks before starting. The most suitable tire pressure, travel speed, or tire type differ according to the condition of the travel surface. Contact your Komatsu distributor or tire dealer for information.
The following is a guide to suitable tire pressures and speeds when traveling on a paved surface with standard tires. (26.5-25-20PR) Check the tire pressure before starting when each tire is cool Front wheel: 0.34 MPa (49.7 psi) Speed: 14 km/h (8.7 mph) Rear wheel: 0.29 MPa (42.6 psi) After traveling for 1 hour, stop for 30 minutes. Check the tires and other parts for damage; also check the oil and coolant levels. Always travel with the bucket empty. Never put “calcium chloride” or “dry ballast” in the tires when traveling. PRECAUTIONS REGARDING BRAKE FUNCTION When traveling long distances continuously downhill, the frequency of using the brake may increase.
As a result, depending on the weight of the machine and the grade of the slope, the machine's braking capacity may be exceeded and the brakes may overheat. The table below shows a guideline of the values for this machine. If the braking capacity limit is exceeded, a forced cooling system for the brakes is needed. Please consult your Komatsu dis- tributor. 2-110 WA480-5L Machine weight (t) Slope grade (%) Braking capacity limit Average travel speed limit (km/h (mph)) Downhill distance limit (continuous) (km) 22 - 24 (unloaded ) 10 40 (24.9) 2 20 17 (10.6) 1.2 28.5 - 30.5 (loaded) 10 30 (18.6) 1.8 20 12 (7.5) 0.6