OPERATION WORK EQUIPMENT AND MACHINE POSTURE Stop the machine on flat ground and put blocks in front and behind the wheels. Apply the parking brake. Secure the front and rear frames with the safety bar. Be sure to put a warning tag on work equipment control levers. Do not go under the work equipment when the arm is raised. ADJUSTING BUCKET The kickout makes it possible to set the bucket so that it automatically stops at the desired lifting height (lift arm higher than horizontal) and the bucket positioner makes it possible to set the bucket so that it automatically stops at the desired digging angle. The setting can be adjusted to match the working conditions.
Set the parking brake Lock the frame of the machine BOOM KICKOUT ADJUSTMENT 1. Raise the bucket to the desired height, set the lift arm control lever at HOLD and lock the lever in position with the safety lock lever. Then stop the engine. 2. Loosen two bolts (1), and adjust plate (2) so that the bottom edge is in line with the center of the sensing surface of proximity switch (3). Then tighten the bolts to hold the plate in position. 3. Loosen two nuts (4) to make a clearance of 3 to 5 mm (0.118 to 0.197 in.) between plate (2) and the sensing surface of proximity switch (3). Then tighten the nuts to hold in position. 4. After adjusting, start the engine and raise the lift arm.
Check that the bucket control lever is automatically returned to HOLD when the lift arm reaches the desired height. Tightening torque: 17.2 ± 2.5 N·m (12.7 ± 1.8 lbft) WA480-5L 2-111