Komatsu — BUCKET LEVEL INDICATOR

OPERATION BUCKET POSITIONER ADJUSTMENT 1. Lower the bucket to the ground and adjust the bucket to the desired digging angle. Set the bucket control lever at HOLD, stop the engine and adjust as follows. 2. Loosen the bolts (1), adjust the position of mounting bracket (4) of the proximity switch so that the rear tip of bar (2) is in line with the center of the sensing surface of proximity switch (3), then tighten the bolts to hold the bracket in position. 3. Loosen the bolts (5), adjust so that the clearance between the bar (2) and support (6) is 0.5 to 2 mm (0.020 to 0.079 in.), then tighten the bolts (5) to hold in position. 4.

Loosen the nuts (7), adjust so that the clearance between bar (2) and the sensing surface of proximity switch (3) is 3 to 5 mm (0.118 to 0.197 in.), then tighten the nuts to hold in position. Tightening torque: 17.2 ± 2.5 N·m (12.7 ± 1.8 lbft) 5. After adjusting, start the engine and raise the lift arm. Operate the bucket control lever to the DUMP position, then operate it to the TILT BACK position and check that the lever is automatically returned to the HOLD position when the bucket reaches the desired digging angle. BUCKET LEVEL INDICATOR (A) and (B) at the top rear of the bucket are the level indicators, so the bucket angle can be checked during operations. (A):

Parallel with cutting edge (B): 90 degrees to cutting edge 2-112 WA480-5L