Komatsu — PERFORMING KOWA (KOMATSU OIL WEAR ANALYSIS)

GREASE MAINTENANCE Grease is used to prevent twisting and noise at the joints. The grease fittings not included in the MAINTENANCE section are grease fittings for overhaul, so they do not need grease. If any part becomes stiff or makes noise after being used for long time, apply grease. Always wipe off all of the old grease that is pushed out when greasing. Be particularly careful to wipe off the old grease in places where sand or dirt sticking in the grease would cause wear of the rotating parts. PERFORMING KOWA (KOMATSU OIL WEAR ANALYSIS) KOWA (Komatsu Oil Wear Analysis) is a maintenance service that makes it possible to prevent machine failures and down- time.

With KOWA, the oil is periodically sampled and analyzed. This enables early detection of wear of the machine drive parts and other abnormalities. Periodic use of KOWA makes the following possible: It enables the accurate understanding of the machine condition by utilizing our long experience and accumulated data base. The report on the result of analysis and recommendation will be delivered to the customer soon at low cost (only the actual expenses will be charged). Use of this service is strongly recommended. WA480-5L 3-13