Komatsu — OUTLINE OF ELECTRIC SYSTEM

MAINTENANCE FILTERS Filters are extremely important safety parts. Filters prevent impurities in the fuel and air circuits from entering important equipment and causing problems. Replace all filters periodically. For details, see the Operation and Maintenance Manual. However, when working in severe conditions, replace the filters at shorter intervals according to the oil and fuel (sulfur content) being used. Never try to clean the filters (cartridge type) and use them again. Always replace with new filters. When replacing oil filters, check if any metal particles are affixed to the old filter. If any metal particles are found, please contact your Komatsu distributor.

When replacing the engine oil filter, fill the new filter with the specified clean oil, then install it. Do not open packs of spare filters until just before they are to be used. Always use Komatsu genuine filters. OUTLINE OF ELECTRIC SYSTEM It is extremely dangerous if the electrical equipment becomes wet or the covering of the wiring is damaged. This situation will cause an electrical short circuit and may cause the machine to malfunction. Do not wash the inside of the operator's cab with water. When washing the machine, be careful not to let water get into the electrical components.

Service relating to the electric system is check of fan belt tension, check of damage or wear in the fan belt and check of battery fluid level. Never install any electric components other than there specified by Komatsu. External electrical interference may cause malfunction of the control system controller, so before installing a radio receiver or other wireless equipment, please contact your Komatsu distributor. When working at the seashore, carefully clean the electric system to prevent corrosion. The optional power source must never be connected to the fuse, starting switch, or battery relay. WA480-5L 3-15