MAINTENANCE 1. Stop the engine and remove the oil level plug (1). Remark Remove the mud and dirt from around plug (1), then remove the plug. 2. Wipe off any oil adhering to the oil level gauge attached to plug (1) with waste cloth. 3. Set the oil level gauge (G) as shown in the right diagram. 4. The oil level is correct when it is between the two lines provided on the oil level gauge. If the oil level does not reach the lower line, add axle oil through the filler port (F). Remark For axles with ASD (Antislip Differential), the brand of lubri- cating oil is different, so always use the specified lubricating oil. 5.
If the oil level is above the upper line, drain off the excess oil through drain plug (P) and check the oil level again. 6. If the oil level is correct, install plug (1). Tightening torque: 132 ± 39 N·m (97.6 ± 28.9 lb. ft.). 3-34 WA480-5L