3. Insert the dipstick (G) again from the top of the oil filler port diago- nally as shown in the diagram, then pull it out again. When doing this, insert the dipstick so that the tip contacts the bottom of the dip- stick guide. MAINTENANCE 4. The oil level should be between the H and L marks on dipstick (G). If the oil level is below the L mark, add engine oil through oil filler (F). 5. If the oil is above the H mark, drain the excess engine oil from drain plug (P), and check the oil level again. 6. If the oil level is correct, insert dipstick (G) into the oil filler pipe, then tighten the cap.
AXLE OIL LEVEL When checking the oil level, apply parking brake and lock the front and rear frames with the safety bar. After stopping the engine, the parts and oil are at a high temperature. Wait for the temperature to go down before starting the operation. Perform this procedure if there is any sign of oil on the axle case. Perform the inspection with the machine on a horizontal road surface. If the road surface is at an angle, the oil level cannot be checked correctly. WA480-5L 3-33