Komatsu — TRANSMISSION OIL LEVEL

MAINTENANCE 11. Drain the coolant from sub-tank (5), clean the inside of the sub- tank, then add water until the coolant level is between the FULL and LOW marks. 12. Stop the engine, wait for approximately 3 minutes, then add tap water until the water level is near the water filler port, and tighten the cap. Check the coolant level and add water, if necessary. TRANSMISSION OIL LEVEL The parts and oil are at high temperature after the engine is stopped, and may cause burns. Wait for the temperature to go down before starting the work. Perform this procedure if there is any sign of oil on the transmission case, or if there is oil mixed with the cooling water. 1.

Start the engine and run it for at least 5 minutes. 2. Open the cap of oil filler port (F), remove dipstick (G), and wipe the oil off with a cloth. 3-32 WA480-5L