Komatsu — CLEANING THE COOLING SYSTEM

Use distilled water for the cooling system water. We recommend use of an antifreeze density gauge to control the mixing proportions. Prepare the following: Container should hold a minimum of 50 liters (13.21 US gal) capacity to mix the coolant. MAINTENANCE 1. Stop the engine and tighten 2 valves (1) of the corrosion resistor. 2. Turn the radiator cap (2) slowly to release the pressure, then remove it. 3. Set a container in position to catch the drained antifreeze mixture, then open drain valve (3) under the left side of the fuel tank and drain plug (4) at the side face of the cylinder block, and drain the coolant. 4.

After draining the coolant, close drain valve (3) and drain plug (4) and fill with city water. 5. When the radiator is full of water, start the engine and run the engine at low idling for about 10 minutes with the water tempera- ture at 90° or higher. 6. Stop the engine, open drain valve (3) and drain plug (4), drain the water, then tighten them again. 7. After draining the water, clean the cooling system with cleaning agent. For the cleaning method, see the instructions for the cleaning agent. 8. Replace the corrosion resistor, then open 2 valves (1). For details of the procedure for replacing the corrosion resistor, see “REPLACE CORROSION RESISTOR CARTRIDGE” on page 3-56. 9.

Pour the coolant and water through the filler port. Fill up to the filler port. See “Mixing rate of coolant and water table” for the mixing rate of coolant and water. 10. To remove the air in the cooling system, run the engine for 5 minutes at low idling, and for another 5 minutes at high idle. When doing this step, leave the radiator cap off. WA480-5L 3-31