Komatsu — CLEANING RADIATOR FINS

MAINTENANCE CLEANING RADIATOR FINS Never open the engine side cover when the engine is running. Stop the engine completely before starting the cleaning operation. If compressed air, pressurized water, or steam hits your body directly, or causes dirt to fly, it may lead to personal injury. Always wear safety glasses, dust mask, or other protective equipment. Perform this procedure if there is any mud or dirt stuck to the radiator. USING COMPRESSED AIR Tilt the aftercooler (1) at the top front face of the radiator, swing oil cooler (2) at the bottom, then insert the steam jet nozzle through the gap and clean the fins. TILTING AND SWINGING COOLER 1.

Turn the starter switch to the OFF position and stop the engine. 2. Pull lever (3) down to release the lock, then tilt aftercooler (1). Turn the knob (4) counterclockwise to release the lock, then swing oil cooler (2). If necessary, band (5) can be fitted to oil cooler (2) to hold it in position after swinging it. Use the steam jet nozzle to blow out the mud, dirt, or leaves clogging the radiator fins or cooler fins. 3. Use the steam jet nozzle to blow out the mud, dirt, or leaves clog- ging the radiator fins or cooler fins. Remark If the steam nozzle is brought too close to the radiator fins, they may be damaged. Accordingly, keep the nozzle away from the fins. 4. Check the rubber hose.

Replace with a new one if the hose is found to have cracks or to be hardened by aging. Further, check hose clamps for looseness. WA480-5L 3-37