MAINTENANCE 5. Loosen the wing bolts (6), use hook (7) to slide cleaning covers (8), and open the left and right covers. 6. Insert the air nozzle and blow the dirt out to the front of the machine. Remark Steam or water can be used instead of compressed air. 7. After blowing out the dirt, install left and right cleaning covers (8). 8. After completing the cleaning, push the bottom of aftercooler (1) to lock it, then push the front of oil cooler (2) to lock it. Check that they are both securely locked in position.
CHECKING ELECTRICAL INTAKE AIR HEATER Before the start of the cold season (once a year), contact your Komatsu distributor to have the electrical intake air heater repaired or checked for dirt or disconnections. REPLACE BOLT-ON CUTTING EDGE It is extremely dangerous if the work equipment moves when performing the turning or replacement oper- ation. Set the work equipment in a stable position, stop the engine, then set the safety lock lever securely to the LOCK position. Turn or replace the cutting edge before the wear reaches the edge of the bucket. 1. Raise the bucket to a suitable height, then put blocks under the bucket to prevent the bucket from coming down.
Raise the bucket so that the bottom surface of the bucket is horizontal. 2. Remove the nuts and bolts (1). 3. Remove the cutting edge (2). 4. Clean the mounting surface of the cutting edge (2). 5. Turn cutting edge (2) and install it to the bucket. When turning the edge, install it to the opposite side (left edge to right side, right edge to left side). If both sides of the cutting edge are worn, replace with a new part. If the wear extends to the mounting surface, repair the mounting surface before installing the cutting edge. 6. Tighten nuts and bolts (1) uniformly so that there is no gap between the bucket and cutting edge. Tightening the torque for the mounting bolt:
745 ± 108 N·m (549.7 ± 79.6 lb. ft.)) 7. Tighten the mounting bolts again after operating for several hours. 3-38 WA480-5L