MAINTENANCE EVERY SPECIFIC HOURS SERVICE EVERY 50 HOURS SERVICE DRAIN SEDIMENT FROM FUEL TANK Open the drain plug (1) on the right side of the fuel tank so that the sed- iment and water will be drained together. EVERY 100 HOURS SERVICE Maintenance for every 50 hours service should be performed at the same time. LUBRICATE THE REAR AXLE PIVOT PIN (3 points) 1. Using a grease pump, pump in grease through the grease fittings marked by the arrow. 2. After greasing, wipe off any old grease that was pushed out. CHECKING THE HYDRAULIC TANK OIL LEVEL AND ADDING OIL The parts and oil are HOT after stopping the engine, and may cause burns. Wait for the temperature to decrease before starting the work.
When removing the oil filler cap, turn it slowly to release the internal pressure, then remove it. 1. Lower the bucket horizontally to the ground. It is correct if the oil amount is between H and L marks on the gauge (G) when mea- sured approximately 5 minutes after the engine stopped. Remark Do not add oil if the level is above the H line. If the oil has been added to above “H” level, stop the engine and wait for the hydraulic oil to cool down, then drain the excess oil from the drain plug. If the oil is above H level, it will damage the hydraulic circuit or cause the oil to spurt out. 2.
If the oil is below the L mark, open the inspection cover on the step and add the oil through the filler (F). WA480-5L 3-43