Komatsu — INSPECTION OF TIRES

MAINTENANCE CHECK Measure the inflation pressure with a tire pressure gauge while the tires are cool before starting work. INFLATION OF TIRES Adjust the inflation pressure properly. When inflating a tire, use an air chuck which can be fixed to the air valve of the tire as shown in the figure. Do not work in front of the rim but work on the tread side of the tire. The proper inflation pressure is shown below. SEMI-PNEUMATIC OR SOLID TIRES The waste handler machines are usually equipped with a semi-pneumatic tire due to the type of environment the machine is exposed to. Inspect the condition of the tire, it is important to keep these tires clean remove any objects embedded in the tire.

If the tire has large chunks of rubber missing or hanging off the tire this may effect the performance of the machine, it is advised to replace the tire. 3-42 WA480-5L Tire size Inflation pressure 26.5-25-20PR (L3 Rock) (standard) Front Tire: 0.41 MPa (58.8 psi) Rear Tire: 0.34 MPa (46.4 psi) 26.5-25-16PR (L3 Rock) (if equipped) Front Tire: 0.41 MPa (51.7 psi) Rear Tire: 0.34 MPa (44.6 psi) 26.5-25-20PR (L3 Rock) (standard)