Komatsu — AIR CONDITIONER COMPRESSOR BELT TENSION

CHECK PARKING BRAKE MAINTENANCE 1. Set the machine on a dry downhill slope. Press the parking brake switch to the ON position. Check if the parking brake holds the machine in position. 2. If any abnormality is found, please contact your Komatsu distributor. ALTERNATOR BELT TENSION The standard belt deflection between the alternator pulley and crank pulley when pressed with a thumb (approximately 59N (43.5 lbf)) should be about 13 mm (0.5 in.). ADJUSTING 1. Loosen the bolts and nuts (1), (2), (3), and (4). 2. Turn the nut (5) clockwise and move the alternator (6) so that the belt deflection is about 13 mm (0.5 in.) (approximately 59N (43.5 lbf)). 3.

Tighten the bolts and nuts (1), (2), (3), and (4) to hold the alternator (6) in position. 4. Check pulleys for damage, pulley grooves for wear, and V-belt for wear. Be particularly careful to check that the V-belt does not touch the bottom of the pulley groove. 5. If the belt has stretched and there is no allowance for adjustment, or it is cut or cracked, replace the belt. 6. After replacing the belt, operate for one hour and adjust again. AIR CONDITIONER COMPRESSOR BELT TENSION The standard belt deflection between the air conditioner compressor pulley and crank pulley when pressed with a thumb (approximately 98 N (72.3 lbf)) should be approximately 16 to 20 mm (0.6 to 0.8 in.).

When a belt tension gauge is used, the standard tension is within a range from 353 to 530 N (260.3 to 390.9 lbf). CHECK WHEN CHANGING THE V-BELT The standard deflection between the air conditioner compressor pulley and fan pulley when pressed with a thumb (approximately 98 N (72.3 lbf)) should be approximately 12 to 17 mm (0.5 to 0.7 in.). When a belt-tension gauge is used, the standard tension is within a range from 530 to 745 N (390.9 to 549.5 lbf). WA480-5L 3-47