MAINTENANCE Remark When the belt has been replaced with a new one, a high belt tension is necessary. Thus, the initial tension is the value given above. 1. Loosen the nuts (1) and (2), and move the compressor (3) to adjust. 2. Tighten nuts (1) and (2) to hold compressor (3) in position. 3. Check each pulley for damage, wear of the V-groove, and wear of the V-belt. Be particularly careful to check that the V-belt is not in contact with the bottom of the V-groove. 4. If the V-belt has stretched, leaving no allowance for adjustment, or if there is any cut or crack on belt, replace the belt. If the V-belt has been replaced with a new one, there will be initial elongation.
Inspect and adjust it again after one-hour of operation. ADJUSTING WHEEL HUB NUTS If wheel hub nuts (1) are loose, tire wear will be increased and accidents may be caused. 1. Check for loose nuts, and tighten if necessary. When checking for loose nuts, always turn the nuts in the direction of tightening to check. Tightening torque: 825 to 1030 N·m (608.5 to 759.7 lbft). 2. If any stud bolt is broken, replace all the stud bolts for that wheel. AIR CONDITIONER RECIRCULATION FILTER 1. Loosen the knob (1), remove the filter inspection cover (2) then open the filter inspection cover (3). 2. Pull the filters (4) and (5) out in the direction of the arrow. 3.
Clean with compressed air in the same way as for the fresh air filter. If the filter is extremely dirty, rinse it in water. After rinsing the fil- ter, dry it completely before installing it again. 3-48 WA480-5L